Code : TUMLanScaper

Download the data sheet

LanScaper

Designed for network technicians, network engineers and IT professionals, the new LanScaper network tester is a physical layer network management device. The LanScaper combines the functions of a high-end cable tester and length measurement device with the capability to monitor and correct network problems connected with the physical layer and link conditions of the network.

Features:

Jack ID mode:
Capable of identifying many of the possible conditions of an RJ45 jack
Automatically runs cable test if no active devices found
Cable Test Mode:
Single-ended testing of cables for shorts, opens and split pairs (no remote on other end)
Full cable test finds all wiring faults including split pairs with a remote connected
Results displayed in wire map format with a message line for shorts and split pairs
Displays PASS icon for T568A/B passing cables and reports cable length
Length measurement in feet or meters using cable capacitance method
Tone generator mode for use with tone tracers
Flash Link LEDmode sends tone while blinking a link indicator to find a HUB or switch port
PING mode:
Simultaneously PINGs three devices at once: a target, a router and a DNS server
DHCP protocol support allows for PINGing of a router and DNS server with no setup
Auto-MDI/MDI-Xlike protocol makes connection to HUB, switch or NIC with any patch cable
Two line by 16 character full alphanumeric backlit LCDwith icons for clear test results
Auto-off in any mode and low power consumption for long battery life

SPECIFICATIONS:

Physical Dimensions:

Size: 15 x 7.4 x 3.2 cm(5.9 x 2.9 x 1.25 inches)
Weight: 200 grams (7 oz.) With battery

Environmental:

Operating temperature: 0 to 50 C (32 to 122 F)
Storage temperature: -30 to 80 C (-20 to 176 F)
Humidity: 10%to 90%, non-condensing

Battery Life:

(9VAlkaline battery, typical) times are for the full capacity of the battery used continuously in one of the following modes:
Standby: 2.5 years
Cable Testing: 50 hours, no backlight
27 hours, 50% backlight
Network Testing: 15 hours, no backlight
14 hours, 50% backlight

Cable Types: shielded or unshielded, Cat5E, Cat5, Cat4, Cat3 and coax
Minimumcable length for testing for split pairs: 1 meter (3 feet)
Minimumcable length for single-ended cable test: 1.25 meter (4 feet)
Length measurement range(CAT5/6): 0 to 457 meters (0 to 1500 feet)

Supplied with:

• 2x RJ45 to alligator clip cables
• 2x “no fault” RJ12 cables
• 2x 1 foot patch cables
• 1x cable test remote
• 1x cordura™ case
• 1x instruction manual