Current-free and voltage-free, as well as current and voltage conducting cables, can be located with the CableCop 300 cable detector system in electrical circuits of up to 300 V. 

Cables, conductors, electrical circuits, short-circuits and ground faults can be localized, and protective conduit and coaxial cable can be traced. The electrical circuit need not be interrupted, and sensitive electronic components need not be switched off. Detection is possible in walls and concrete, as well as underground.

Receiver:

Mode selection:                  Closed measuring circuit, live line max. 300 V
                                          Open measuring circuit, electrically dead line
Range selection                  Amplification: x 1, x 10 or x 100
                                          with vernier amplification setting via thumb wheel

Signal generator (Measurements on live lines):

Operating voltage               9 V ... 300 V AC/DC
Operating frequency           32 768 kHz
Signal                                 Clock cycle 0.5 s; 2 pulses of 0.0625 s duration each

Transmitter (Measuring on electrically dead lines):

Operating frequency           32 768 kHz
Signal                                 Clock cycle 0.5 s; 2 pulses of 0.0625 s duration each