On-line Verkauf von Werkzeugen von Test und Maß

Unlike any other current probe

The Aim I-prober 520 positional current probe is unlike any other current measurement device available.

Calibrated measurement of current normally requires the current to be passed through a closed magnetic loop. Typically this is done using some form of split clamp device. Whereas this is suitable for individual wires, it is of no use for measuring current in PCB tracks.

The I-prober 520 is a compact hand-held probe which is used with an oscilloscope. By placing the insulated tip of the probe onto a PCB track, the current flowing in the track can be observed and measured.

Observe and measure current in a PCB track

Make measurements via non-contact probing

Suitable for observation and measurement of current in
   component leads & ground planes as well as PCB tracks

Wide dynamic range of 10mA to 20A pk to pk

Wide bandwidth of DC to 5MHz

Low noise equivalent to <6mA rms at full bandwidth

Minimal disturbance to circuit conditions through very low
  insertion impedance and stray capacitance

Safety rated to 300V Cat II (600V Cat I)

Suitable for connection to any oscilloscope

High accuracy general purpose H-field probe